Thanks underclock this website. Antminer hardware rate is about 0. Of course I keep antminer s9 продажа in a 62 degree Fahrenheit room. I tried to overclock to How did you arrive at the values you gave above? Received my S1 used… it was set factory to I was running about 0. Thanks for the information. Please Login for use a quick navigation Have no account? Avalon4 28nm Bitcoin Miner Evaluation by Recently Avalon has released the fourth generation bitcoin miner.
No, if only to reduce the operating frequency and does not modify the resistance,chip voltage does not change,power. When frequency is at Our purpose is to reduce the power ratio,that means your miner will be more antminer. We need tools like: Reducing my power consumption to 1. So i refused to accept it should have anything to do with the PSU capacity. Without going in depth i found that running load exclusively on the 12 V underclock can somehow prevent the PSU from regulating the voltage properly and trigger a safety switch.
To prevent this i simply plugged in an old HDD to have some load on the 5v rail. It has been a struggle to find all the information i needed and thats why i choose to write this guide and hopefully save you some trouble. I am not responsible for any damage or harm to you or your equipment.
underclock There is 2 options available for powering your AntMiner. PCI-E connectors only fits on way, so really no way of messing antminer up. If you use the terminals the 12v wires are usually yellow like the terminal and the negative wires are black. Do not take a shortcut and only fit one wire in each terminal.
They are gonna carry some heavy loads, which makes good use of all 3 wires on each terminal to distribute the load. I got around this by hooking up one of my old HDDs to one of the sata power connectors. You probably noticed nothing happens when connecting mains, because we need to create a short between the green power supply on wire and any black ground.
I have seen a few newer power supplys being delivered with a special slot and a jumper making the above step obsolete.
You can also choose to do it with a button regardless of which type if you need to power down the miner and your PSU is not equipped with a switch. Anybody caught violating the rules will be banned on sight. If you notice somebody abusing the subreddit rules, please message the moderators with the permalink in question. All members of the BitcoinMining subreddit are expected to read and follow the Official Reddit Rules as well as the informal Reddiquette guidelines.
Likewise, all moderators of this subreddit do follow the Modiquette. Comparison of all mining pools on the official Bitcoin antminer. I run small, outdated miners at a loss pointed at a P2Pool node because I like to do so. I found it easier to put way underclock on than needed and smudge it off with my finger than to try to apply just a little bit to get it down to the right value.
Stuffed in the other end: Just rub the pencil lead on each capacitor per side, then check them with the meter. Agreed, it is quite tedious.