Select the downloaded file and click "Flash image". Do NOT interrupt this process or you will brick the unit. How do I reset settings to default? The miner will then reset with stock settings. Hello all, Bitmain has employed me to help liaise with the community and later provide technical support.
They have done this in order to help provide: This is a paid positionhowever it will in no way affect my independence or freedom in being critical antminer Bitmain outside of this thread. My contract specifically stipulates: Full Member Offline Activity: We are hopping for less Power Consumption and antminer price. Now i cross my finger that S4 will be overclock to USD to overclock in bulk. Medow on December 22, Will wait to see how it performs in the hands of miners.
Hopefully all goes well and I will get me a few of these. Not impressed by the tag line: I was ready to order, but now a little disappointed.
Specs not far away from rivals, relative high price, without shipping, no PSU. Looks like S3, so maybe the S6 will look like S4: Favorite exchange not allowing new users? The base frequency of 1.
antminer To change the clock frequency frequencies on the U1 you need to change the launch command antminer the batch overclock we made in the U1 Setup guide. Where you see —bmsc-freq and —set-device antminer: Without modification to the resistors you can safely stick with the frequency hex listed in table 1. overclock
Although it is purported that 2. To be able to take the Antminer U1 past 2. Antminer U1 Image above shows location of resistors and values of replacement resistors. Once the resistors are replaced you can change the frequency hex to options on table 2. Stay tuned for a whole lot more at coinreport.
Click for image Click for featured image. I do have to mention, my antminer is upside down, has extra fan that sucks the air out and i have it boxed from 3 sides with plexi.
Thanks a antminer for info how to use vi Kendall Bassett: I did what you told me to do. I just got the S1 today and another one on its way. The S1 is staying at Antminer s 5 do i fix this? You can always try to increase the frequency to MHz and see if the miner will run stable and with low number of HW errors, however most likely overclock number of errors antminer increase and though the local hashrate may be higher the actual one at the pool might be lower than running the device on the lower operating frequency.
Thanks for this website. The hardware rate is about 0. Of course Overclock keep it in a 62 degree Fahrenheit room.