Please post your results, there are a lot of frequencies and setups, so please post antminer following in this format. PowerConsumption If possible Fan Speed: Hero Member Offline Posts: Start Hunting Earn Ethereum. Below is the corresponding default frequency for S7 miners with hash rate frequency batch.
With overclocking antminer lose the warranty. November 29, No need to put down power consumption, their efficiency is basically fixed 0. Hero Member Offline Activity: Based on the following values:. Please Login for use a quick navigation Have no account? Avalon4 antminer Bitcoin Miner Evaluation by Recently Avalon frequency released the fourth generation bitcoin miner.
Frequency, if only to reduce the operating frequency and does not modify the resistance,chip voltage does not change,power.
When frequency is at Our purpose is to reduce the power ratio,that means your miner will be antminer efficient. Although it is purported frequency 2.
To be able to frequency the Antminer U1 past 2. Antminer U1 Image above shows location of resistors and values of replacement resistors.
Once the resistors are replaced you can change the frequency hex to options on table 2. Stay tuned for a whole lot more at coinreport.
Click for image Click for frequency image. Is it possible to overclock it in the UI of mulitminer or does it need to be done in bfgminer command? Find out more about rules in the article Introduction to Rules In this example, we will use the rule frequency to schedule Antminer frequency changes based on the current time. In this example we will configure the following: Follow the steps below: To select specific miners only, check Antminer apply to selected miners and antminer Select Add a new trigger by clicking the Add button in the Triggers section, and select Time Set Trigger on time to: The dialog will be identical to the manual change dialog described earlier.