At-mr.ru

Config antminer s1

Tigggger on November 24, Textplorer on November 24, config, Xian01 on November 24, If you run into assholes all day long, you are the asshole. Unacceptable on November 24, Hero Member Offline Activity: Before you received the goods, you want to read this carefully. If you have any questions, please config. First, you have antminer connect your computer and the miner directly with an Ethernet cable. Then you manually set your IP address at XXX, so you can browse the control panel.

This is very similar to other OpenWRT antminer miners. Disconnect all the power cables from the 2nd Blade. Then Power On the AntMiner. If config really want to test out the 2nd Blade, then replace the 1st Blade with the 2nd Blade. By the network cable port, there are 2 white plugs. Make sure both are connected to the 2nd blade If its antminer u1 bitcoin miner on, then the problem is for sure in your PSU.

Please go get a brand name reliable PSU. Depends on your PSU Model, it may fix your looped auto-shutoff http: Please look at the above photo. You will probably need to clean antminer outside of both of your blades for minutes each. This thermal paste leaks up through the screw holes and from the edges of the circuit boards.

AntMiner S1 Tutorial

My suggestion is antminer use soft paper towels and no cleaning fluid. Others have reported good config with rubbing-alcohol. You not only need to remove as much visible thermal paste as you can, but there is also an oil within the thermal paste. Both the paste and this oil can short-circuit various portions of the circuit board. The oil can be very hard to see.

config antminer s1

You should use the reflection of a config to determine where the clear oil is on the circuit board. Do your best to clean it up. We clean up all thermal paste that we can get to, because when the device heats up under use, it will tend to run down the circuit board if there is much of any left on the antminer board. So, clean what you can, and check the device after 10 minutes of run time to make sure more paste did not sneak out from the screw holes.

Now, placement of the S1 is important. One into each blade. There should be a 6-pin input female connector in the top center of each blade. Now, antminer s5 прибыль your power connected but not turned on yetplug in your Ethernet cable. I have not personally confirmed this myself, but there may be a reason to go via Ethernet cable. Wait approximately 45 seconds after turning the power on before deeming everything as stable.

antminer setup - at-mr.ru

We wait, because mining does not actually begin for approximately seconds after turning the device on. If all is well so far, it is time to connect to your AntMiner S1 and configure it. Log into a computer on the same network as your AntMiner S1. Obtain the IP address of the S1 -- it should be on a sticker near the main fan. Most devices seem to have I will show you how to change the IP address shortly.

Load up your Internet browser I recommend Chromeand navigate to http: You should be taken to a login screen.

config antminer s1

Похожие статьи:

  • Продаю antminer s5
  • Antminer s9 купить цена
  • Antminer s9 температура работы
  • Msi gtx 1070 armor 8g цена
  • Antminer купить спб
  • Antminer s9 14th купить

  • Рекомендуем почитать:

  • s9 асик antminer
  • antminer s9 шум
  • msi gtx 1080 armor 8g oc характеристики
  • At-mr.ru - 2018 (c)