At-mr.ru

Antminer s4 firmware

Connect the miner to the router by internet cord.

Dogiecoin - Bitmain Antminer S4 - DogieCoin

Power on the miner. Press the switch button as the following picture showing on the miner for a few firmware until the fan and the LED light run. There is a specific ip address for every miner. From the LED, you will get the ip adress of your miner. Plug firmware a power cable from antminer AntMiner to the mains Plug in an ethernet cable from the AntMiner to you router. Power on the power supply using its push button at the back. If not then change it to 1, this is just temporary. Login using "root" as both the username and password.

Using a browser, navigate to your router and find the IP it has assigned the S4 and navigate to that IP. Enter your pool information in the below format. Navigate to antminer page "Miner Status" antminer check firmware has started. You can then change your router subnet back to whatever you are used to using. Unplug your computer from all internet sources. Plug in an ethernet cable from the Antminer to your computer.

Click on "Internet Protocol Version 4" and click properties.

ANTMINER S4 firmware by smit | Page 5 | at-mr.ru

antminer wikipedia Now reboot your S4 and enjoy. S4 firmware by smit Just wanted to say big ups for the antminer, Works great. I notice somewhere u said the speed of the fans was reduced by rpm. I was wondering how safe firmware was?? Thinking about this, Is there anyway to drop the fan antminer by firmware instead of so i can run this puppy full speed rather than the current freq 62 deg c? It is much better than their last Oct. Is there any way you can fix that?

Bitmain Antminer S4 Review: 2 th/s Bitcoin ASIC Miner Needs PSU Replacement

It only allowed 3 of the 4 hash boards to be adjusted, while the 4th board was stuck at v. Not antminer good for efficiency. The use of DHCP can make for an easier time getting the miner on your network especially if you use a nonstandard addressing system or IP address setup. The first thing I will suggest is you to flash the unit to the newest firmware. The new firmware contains the cgminer 4. With the shipped firmware on batch one, you will find that many times the hash rate will not report correctly, and poolside will firmware show up as less than half or less antminer the total hash bb board for antminer. Make sure to set the difficulty to on your pool.

Right now BTCGuild works the best. firmware

antminer s4 firmware

Ghash and eligius work but not up to full speed with the newest firmware. We were not able to get it to work well with P2Pool.

antminer s4 firmware

NastyPool gave me the best results at roughly 1. You need to be in directory where your image is located or you need to write complete path to your image on last command. Process is pretty straightforward and easy to do. First insert your microSD card in your card reader.

antminer s4 firmware

Check in my computer that your card is present and healthy.

Похожие статьи:

  • Antminer d3 пул для майнинга etherium
  • Antminer s5 2017
  • Antminer s5 как настроить
  • Antminer s1 купить
  • Bitmain antminer s1 что это

  • Рекомендуем почитать:

  • gtx 1060 armor 6g ocv1 overclock
  • At-mr.ru - 2018 (c)