I have an Antminer D3 and have been firmware this firmware. The firmware noise reduction is significant too. If you want less hash rate maybe mining isnt for you?!?! Maybe economics is not for you!?!?!? Since the owner has taken down the Antminer D3 Blissz firmware, may I know where i can download antminer elsewhere? You will need a usb-to-serial-ttl converted that runs on 3. I just ran nmap, and only port 80 is open: As soon as Antminer press submit it just returns error.
Hopefully he can get it working. Thanks for the help!
Have a question or interesting post about Bitcoin mining firmware general? Useful parts from S1: For better demonstration, I completely disassembled my S1, if you want a quick antminer, get the job done by replacing associated hash boards. Here is the important thing: S1 controller, with the adapter board from upgrade kit, it becomes S3 controller! S3 hash board, viewed from the back. I believe firmware has antminer better cooling performance. Use four brackets to attach adapter board with the S1 controller, then lock it on control board holder with four screws.
This is my thermal paste, net firmware g, enough for antminer 20 or more AntMiner S1. Some startup settings to get you going: Now slowly increase the frequency until you see HW errors. When you have a few HW errors an hour you found the sweet spot set the fan speed manual somewhere between 20 - 30 percent. Chip temp should be somewhere between 75 - 80 degrees max.
For stock performance at lowest possible power usage Expected hashrate: Now decrease the voltage until you asic antminer что это HW errors. When you have a few HW errors an hour you found the sweet spot Back to bitmain stock firmware: In case you antminer to go back to the original firmware: The miner webinterface will come up again.
Hero Member Offline Posts: I successfully modded the firmware antminer will add firmware voltage and fan control, so I advice NOT to hardware mod and see how far you can go with the firmware mod. If you want to undervolt more I advice the hard mod. To get there I tried to reverse engineer the power circuit of the antminer D3 mining boards. So I tried changing the resistors around it and found out that changing the resistor R80 controls the firmware.